DEGREASING/TOUGH CLEANING
|
2 ounces to 1 Quart of HOT Water
(1/2 Pint = 1 Gallon)
FOR EXTREMELY DIRTY: USE PASTE DIRECTLY ON HOT SURFACE
EnginesOvensWall CleaningStripping FloorsSoap build-up in bathroomsRust marks on porcelain (Use 3M Scotch Brite)Washing extremely dirty cars, boats, trucks, airplanes and RV'sRestaurant and other Commercial cleaning problems, BEST ON HOT SURFACE!
| |
Apply thoroughly for degreasing equipment, through pressure washers, steam cleaners, floor scrubbing machines, etc. For best results MICROWAVE ENTIRE CONTAINER WITH LID OFF FOR 30 SECONDS, pour 2 oz. or 10 - One in spray bottle. For engines and ovens, apply on hot (@250) and let stand on warm surface for 10-15 minutes, then scrub you may have to reapply rinse,wipe dry. No toxic fumes. For most other surfaces, apply mixture, work in with normal washing materials and rinse.
|
CARBON REMOVAL FROM POTS AND PANS: Spray pre-heated pot in sections until there is a steam coming off surface. Wipe with 3M green Scotch Brite. Rinse as usual. If carbon is thicker than a fingernail we recommend using a stainless steel pad instead of a 3M green pad to help remove the build-up with out gumming up the 3M green pad. Repeat process if necessary. GRILLS AND FLAT TOP GRILLS : USE 2 0Z MIXTURE TO 1 QUART HOT WATER ON HOT SARFACE. SPRAY AND SCRUB IN SECTIONS. FOR BEST RESULTS CLEAN AT THE END OF NIGHT WHEN GRILL IS TURNED OFF. AFTER CLEANING EACH SECTION WITH EITHER METAL SCRUBBER AND /OR 3M SCOTCHBRITE. RINSE ENTIRE SURFACE WITH WATER AND RE-OIL.
OVENS AND HOODS: Pre-head oven between 250-300 degrees then spray in sections and remove sprayed area within 5-10 seconds with stainless steel pad. Wipe clean with wet towel when surface is cool. For thin grease a 3M Scotch Brite works even better than a steel pad.
FRYER BOIL OUT: 1 OUNCE OF COMPASS (FOR EXTREMELY BAD 2-3 OZ). TO A FULL VAT OF WATER AND COOK @200 DEGREES FOR 20 TO 30 MINUTES. DO NOT OVER HEAT COMPASS WILL FOAM AND BOIL OVER IF HEAT IS TOO HIGH. PLEASE WATCH AND CUT HEAT DOWN MORE IF IT STARTS TO FOAM. DRAIN AND RINSE WITH WATER REFILL WITH OIL AND YOU ARE READY TO COOK!
NOTE: COMPASS IS SAFE ON ALUMINUM SURFACES AND ALL GALVANIZED TYPE HOODS. DO NOT USE 3M SCOTCH BRITE ON ANY GALVANIZED SURFACE. IT WILL SCRATCH FINISH.
FLOORS AND BASEBOARDS: Add 1/4 cup of COMPASS to standard mop bucket with HOT water. To sanitize add a cup of bleach OR ammonia, but do not mix those two together ever. Apply mixture with string mop or deck brush. If possible let sit 5-10 minutes then mop up with the rest of solution. Rinse with water or hose off floor. For thick grime on quarry tile spray first with solution and rub in with a stainless steel pad then mop as usual.
COMPASS IS SAFE ON PAINTED SURFACES WILL NOT ETCH.
FOR ANY QUESTIONS OR COMMENTS CALL
1-800-966-4930.
THANK YOU FOR USING COMPASS CLEANER!
|
|
